IT: Connecting to the Victoria EduSTAR wired network - BuildBee Support

IT: Connecting to the Victoria EduSTAR wired network


There following things need to be done when connecting a BuildBee CloudDock to the EduSTAR wired network. For full instructions on configuring a BuildBee CloudDock, please refer to the Configuring your BuildBee CloudDock help article.

Step 1 - Whitelist BuildBee domains

- Check that the sites at test.buildbee.com and test.buildflow.online are whitelisted for the proxy.  Ideally these should be added to the globally authentication list.  The easiest way to whitelist the required domains is to add buildbee.com, *.buildbee.com, buildflow.online and *.buildflow.online to cover all subdomains. For more information, refer to our IT: Domains for whitelisting help article.

Step 2 - Configure your BuildBee CloudDocks

- When filling out the configuration details, choose the 'WIRED WITH PROXY' option.
- Fill out the proxy details for both HTTP and HTTPS traffic using proxy.education.netspace.net.au and port 8080 for both sets of fields.
Using the direct IP address has been found to be more successful than the fully qualified domain and may be an option if it is known.
Here is an example configuration:
Victoria netspace proxy settings


    • Related Articles

    • IT: iDET Queensland connection process

      There following things need to be done when connecting a BuildBee CloudDock to the Queensland iDET network. For full instructions on configuring a BuildBee CloudDock, please refer to the Configuring your BuildBee CloudDock help article. Step 1 - ...

    • Get Started with BuildBee

      Congratulations! You’re the proud new owner of our latest and greatest CloudDock! With this awesome piece of technology, you can control your 3D printer over the Internet. BuildBee is comprised of two products. Firstly, a physical control box called ...

    • IT: NSWDoE Schools Installation - central server connection

      This guide is for schools using the "detnsw" network and connecting to the central server.  Configuration for schools using the "Internet @ edge" method may connect differently. To connect your 3D printer to the BuildBee app, you must first configure ...

    • DET Edge network support updates (can't configure, printers offline)

      DET NSW are beginning to roll out a new internet service across all of their schools which changes the way devices access the internet. As a result of this change, our BuildBee CloudDock devices have been affected in the schools that have been rolled ...

    • Create or connect a BuildBee CloudDock

      You can now make your own BuildBee CloudDock with existing Raspberry Pi hardware using the built in wizards in BuildBee Desktop. Simply launch the wizard and follow the steps. Prep - Make sure you have all the required hardware - Raspberry Pi 3B or ...